WTF

767 Views 5 Replies 4 Participants Last post by prophanger1, Oct 30, 2004

prophanger1

Discussion Starter · Oct 26, 2004

OK I'm assembling a plane covered in china cote well i went to shrink the covering on the h stab and it went and did a banana i tried to flip it over and heat the other side well it looks like a bunch of curves its all warped up how can i get it strait

that stuff Will shrink

Save

1 - 6 of 6 Posts

crazystix

· #2 · Oct 26, 2004

Put it in the refrigerator? I dunno, man, that sux.

Save

3d-aholic

· #3 · Oct 27, 2004

You used a heat gun didn't you...?

You know the answer...you just don't want to hear it.

Yep...Pull it off and apply new ultracote.... :wink: In 90% of the circumstances, you should use an iron on low and work yourself up. That Heat gun can take a small issue and make it a huge problem in about 3 seconds.

Save

prophanger1

Discussion Starter · #4 · Oct 27, 2004

will do as soon as i rebuild the piece me smashhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhh :twisted:

:lol: me feel better

Save

BIZZARO

· #5 · Oct 30, 2004

Been there..Done that..... :drink:

Have a drink... 8)

Save

prophanger1

Discussion Starter · #6 · Oct 30, 2004

its all better now so is my hand from using it as a iron stand woh i have had some wild days cut the stabs off two profiles recovered one stab from doing the banana dropped my sukhoi on my toe

:drink: yum yum

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month