The Profile Brotherhood RC Forum banner
1 - 1 of 1 Posts

· Registered
8,728 Posts
Discussion Starter · #1 ·
Ok, my landing gear wheels are getting lathed out internally using screws as axles. These wheels are gettin expensive to replace...seems I need a dozen in my box. The standard on profiles is regular screws to hold on wheels so whats the secret.

Barely 6 landings and the wheels are already getting whobbly...

I know not a big deal.... :roll:
I was thinking about putting heat shrink tubing on the screw to reduce the axle drilling.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.