The Profile Brotherhood RC Forum banner
21 - 26 of 26 Posts

·
Registered
Joined
·
2,583 Posts
Discussion Starter · #21 ·
Find the CNC pieces for the elevator and assemble as shown. Use sticks as shown to complete the elevator. Remove and sand.
Rectangle Slope Triangle Font Line
Rectangle Slope Font Triangle Line
Rectangle Triangle Wood Font Slope
 

·
Registered
Joined
·
2,583 Posts
Discussion Starter · #23 ·
Now for the best part, the fuselage.
There are several CNC pieces, a carbon tube and sticks that are used here.
First glue together the two CNC pieces at the front end. Continue gluing the CNC pieces and tube together as shown then fill in with sticks as shown.
Rectangle Font Slope Parallel Pattern

Rectangle Slope Font Parallel Wood


Snow Rectangle Pattern Composite material Metal
 

·
Registered
Joined
·
2,583 Posts
Discussion Starter · #24 ·
Now final sand everything and sand the bevels for the hinge lines. You will notice that you still have the plywood parts for the motor mount, landing gear & tail skid. I prefer to glue these all on after covering. The airframe is now ready to cover.
Font Wood Motor vehicle Rectangle Automotive exterior
 

·
Registered
Joined
·
462 Posts
Hey Doug. Outstanding job on that build. I really enjoy that size plane. Had an ARF profile a bunch of years back that flew amazing but is discontinued like everything else. Is this available as a kit? Lmk, thanks!
Rick
 
21 - 26 of 26 Posts
Top