The guy that kits these uses hot glue (low temp) to build them. I was just going to use foam safe CA until I saw him fix an ele in about 3 seconds. I have a 4 dollar low temp glue gun setting next to me. It could be the future.
Thanks Bro's...BH.....O.K, axi it is. Do I need the 22 dollar mount? Also, what lipo? 2s1....3s1? I have some Etec 1200's (3s1) Is the CC10 O.K?
I know you (BH) work for HL so its hard to recomend something else but I really like my Castle creations speed controlers Billy, do I just order the Raptor and wait? When its in stock will they (HL) let me know? Thanks.
The Raptor is a very good flyer especially in KE and Harriers, however you must place the battery pack behind the motor in the thrust line or it will corkscrew out of a manuever for example the last point of a 4 point roll. If you are flying and this happens the problem lessens when you throttle back so you can land it. This plane does not like an aft CG. Mine seems to fly well at about 1.5" from the center LE.
Thanks Scott, I went with a himaxx 0980 outrunner and a 10x4.7 cc10 etec 1200's (3s1) that I had lying around.
I maidened it about 4 months ago;}
Flys great, never had a plane hands off knife edge, really Cool.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.