The Profile Brotherhood RC Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
445 Posts
Discussion Starter · #1 ·
i was ripping the guts out of my trainer to put into the sledge and i went to take the receiver out and the atenna was somehow glued to the bottom of a servo. It seemed to come ok and all of the sudden it just let go and ripped the wires apart. I was wondering if i can just splice it back together, or do you think horizon would fix it? :?: :?:
 

·
Registered
Joined
·
5,519 Posts
If you are comfortable soldering on a circuit board...JR sells the antenna wire. Just open the case and solder the new 1 on.
If not send it in....They can fix it.
 

·
Premium Member
Joined
·
13,286 Posts
or just cut it and splice on another piece or 22 guage wire just keep the total length the same length as the origonal thats way more imprtant than thickness of wire or anything else, solder the new piece on and shrink tube or tape the exposed wire :D
and do a range test as usual
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top