The Profile Brotherhood RC Forum banner

Jack Knife ARF by Hobby Lobby

396 Views 2 Replies 2 Participants Last post by  3d-aholic
Anybody got one?
1 - 3 of 3 Posts
where are the specs amd pics on it, i went to hobby-lobby and did not see it?

32" wingspan, 33" long, 352 sq. in. wing area, 21 oz. flying weight, 8.6 oz./sq. ft. wing loading. Laser cut, pre-built and covered with quality heat shrink transparent covering. Simple assembly takes only a few hours. Its lightweight structure, thick airfoil and generous wing area, make this a delight for flying 3D maneuvers. If you are new to 3D, this model will help you learn with its predictable flight performance. Comes with pre-bent wire landing gear, wheels, hinges and hardware. Model uses 2 aileron servos allowing you to program flaperons for tighter loops. Requires 4 channels for Ailerons (2 servos), Elevator, Rudder and Throttle.
See less See more
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.