[mfeuilly]

http://www.michaelconnally.com/images/v ... heedge.wmv

more infor here http://www.rcgroups.com/forums/showthread.php?t=219647

I got to see its first indoor flight, and it was awsome!!

 

[adrenalnjunky]

that was impressive that it hovers that well on a razor350 with GWS D gearing, 3 cells and a 13X6.5 prop

I didn't see the mah rating on his cells, or their config, but I just bought a himaxx 2015-4100 and this thing is giving me evil thoughts :twisted:

 

[mfeuilly]

I think the pack was either a 1200 etec or a 1500 kokam.

 

[adrenalnjunky]

Do you happen to know which cofiguration 3s1p, 3s2p, etc???

No biggie, my foamie is going to be smaller, but not a whole lot lighter due to construction methods.

 

[mfeuilly]

3s1p

 

[Gordo]

Man that is impressive. I never thought about going that big on a flat foam flane. What a trip!!!!!!! I would dearly love to take that baby to a IMAA event. What a hoot to see the faces on the guys with the $8000 planes when you hover right next to them!!! (bad Gordo, bad!)

 

[TailTwister]

I would have never guessed that the little brushless would pull such a plane only on 3 cells.

I guess I can forget about limiting myself to 36 inches...

 

[stickit]

I think with the time flown he was probably using a 2100 mah wich I have sitting on the shelf from my old fatty. guess what I'm doing on sunday :twisted:

 

[stickit]

will probably be 4'x4' though to keep it in sorta scale

 

[mfeuilly]

I think it was either 1200 or 1500mah cells.

 

[pencil shavings]

how many amps does that 350 pull with the 13 6.5?? I didnt know it would take it..

 

[Ulf]

how many amps does that 350 pull with the 13 6.5?? I didnt know it would take it..

:shock: that is too much prop for the razor 350 !

 

[mfeuilly]

depends on the ratio. If its a D, then I would guess around 15amps, but its been a while since I've played with Razors. On his site, it says its powered by an RZ400, which would be much more reasonable on a 13x6.5 with a D ratio. He did have some motor problems with it. One time it gave up over an indoor pool, and went in. I forget exactly why it gave up.

here's his site: http://www.michaelconnally.com/current.htm

 

[rcsHELI]

Can any of you tell what the amp draw is. I have two park 370 on the shelf doing absolutly nothing. THis could be an interesting show at the field.

 

[AndySteere]

My E-Flite Park 370 4100kv, Cobri gearbox @ 6.6:1 ("D", 66t-spur, 10t-pinion), APC Thin-E 13x6.5 pulls 12.4 amps from a 3S Tanic 1550 pack.

I run this prop on my FancyFoam SU-29. Pulls as well as a 12x6sf, but doesn't break if it touches the ground (might break the stick though). Does have more torque induced roll than the 12" prop, as one would expect.

Should be fine with a Razor 350 too (4200kv), but will pull a couple more amps.