The Profile Brotherhood RC Forum banner

Help with OMP Yak 55sp 65"

2K views 24 replies 5 participants last post by  SkrPlyr23 
#1 ·
Rebuilt a crashed yak54 profile... looking for placement of landing gear and where to spot the cg. Could use a manual or some help! Thanks everyone !
 

Attachments

See less See more
1
#4 ·
Hopefully when it was rebuilt, there were hard points added where the gear need to go. You don't want them too far forward or back. This is the RadYak I just finished and this is where and I would put the gear. The gear should be angled forward about five degrees. Put a piece of tape on the fuse, draw a line square to the bottom. Hold the gear up with one hole in front of the line, top hole behind.
 
#13 ·
Have that one too but never did anything since I didn't like how the ARF flew.
It did have some 1/4 pieces of plywood glued to the fuse when I got it.
I'll see if I can find the plans, unless Mo beats me again. :mrgreen:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top